Description
HQ Holden wiper Blades. This Wiper Kit has been developed to replace the original wiper arms and blades that utilised the extra cantilever arm on the drivers side by simply removing the arm and pin (not necessary)A near full sweep of the windscreen is achieved on the drivers side
HQ HJ HX HZ WB Holden Wiper Blades Classic style quality hand polished English made stainless steel wiper arms and blades to suit Holden HQ to WB. Suits early model Holden sedan, wagon, coupe, ute and panel van. Belmont, Kingswood, Premier, Statesman, Caprice, Monaro from 1971 to 1985. Kit includes 2 wiper arms and 2 wiper blades (wiper arms are 365mm long – measured from the centre of the spline drive to the end of the arm). Wiper arms are cranked 15° to accommodate replacement of the original wiper arm head. The wiper assembly includes the splined wiper arm that attaches to the windshield wiper spline (5/8” | 15.9mm) diameter) plus the replaceable clip on backing and rubber blade (18”|460mm). Made from stainless steel the combination of spring loaded wiper arm and wiper blade will work with original wiper motor system on the HQ HJ HX HZ WB model. The spring loaded wiper blade ensures a positive contact with the windscreen. Installation guide also included. No Special Installation tools required. Installation guide included. These are not a cheap imported knock off.
If you are struggling to find a decent set of original arms and blades for your HQ to WB (modern style “helicopter” wiper blades do not suit the classic style of original HQ to WB) you can simply by-pass the counter-lever pin and arm (remove the cantilever arm from the drivers side) and retrofit your HQ to WB wiper system with earlier style Wiper arms that utilise the classic style bayonet style fitting (as opposed to the “helicopter” style blades)
Classic Style Stainless Steel Wiper Arms (1 Pair) For HK Holden
